1.Damage of industrial door cables
Cause and solution: The cable is slack; in order to prevent the situation
from getting worse, please replace the cable before the drum shaft is
wound.
2. Industrial sliding door falling
Causes and solutions: spring damage; install bulletproof spring damage
device, according to maintenance records, replace the spring before the maximum
number of times the spring is used.
3.Industrial door cushioning is not good
Causes and solutions: damage to the lower pad; replace the damaged
pad.
4.The door panel may pinch your fingers
Causes and solutions: The door hinge of the industrial sliding door of JIANDA Door Industry is incorrectly installed; reinstall according to the specifications of the manual.
5.The protective shell is easy to fall off
Causes and solutions: During installation, the protection shell is not
protected from derailment; choose a suitable protection shell support frame, and
rewind the cable before the problem is removed.
6. Rapid rise of industrial doors
Causes and solutions: Exceed the load capacity of the spring; observe the
regulations of the number of springs, and re-adjust the number of springs.
7. The door is often damaged by foreign objects
Causes and solutions: There are no obvious safety signs, which makes people
or animals easy to hit the door; Post warning pictures or use flashing lights as
reminders.
8. Gears can easily catch clothes or other things
Causes and solutions: Use isolation devices; install isolation fences or
place isolation devices. Do not approach when the sliding door is running.
9.Industrial door operation is unstable
Causes and solutions: The spring is not loaded; regularly check the balance
and bearing capacity of the spring.
Leave your request and email in the message box below, we will contact you soon.
Send comments
发表评论: